Ti-nspire Press-To-Test mode?

[Moini92]

What are you supposed to Tick on/off when putting the TI-Nspire on Press-To-Test Mode? please answer ASAP as I have Paper 2 Math SL tommorow morning!!!

[XeoKnight]

1. Turn Calculator off.

2. WHILE calculator is off, press and hold down esc and the home icon at the top, and the on key to bring up the Press-to-Test Mode dialog box. All three buttons at the same time!

That should bring it up, if you need more information on what to do after that pm me.

Sorry, didn't read your post right. This I copy pasted from one of the IB docs our grade coordinator sent us:

TI Nspire “Press to Test” configurations.

Note: Candidates must upgrade their Nspire to the latest operating system to use the “Press to Test”

properly. Nspires which have not been updated and put into the correct “Press to Test” mode are not

allowed in the examinations. Further details about “Press to Test” can be found at the end of this

document and on the TI website. Older versions may need two upgrades to enable the correct “Press to

Test” mode.

The following options in “Press to Test” mode must be ticked and therefore blocked.

 Limit geometry functions

 Disable function and conic grab and move

 Disable vector functions, including eigenvectors and eigenvalues

 Disable “isPrime” function

 Disable differential equation graphing

 Disable 3D graphing

 Disable implicit graphing, conic templates, conic analysis, and geometric conics

The following options in “Press to Test” mode must be unticked and therefore allowed.

 Disable inequality graphing

 Limit trigonometric functions

 Disable logbx template and summation functions

 Disable Polynomial Root Finder and Simultaneous Equation Solver

Edited May 9, 2013 by XeoKnight